Wednesday, November 19, 2008

Building the Microhouse

A few years ago I read a magazine article about a microhouse on wheels. A woman had a tiny house on wheels that she lived in, that she parked in a friends back yard. Not a motorhome, nor a travel trailer (similar to) but an actual house. It later inspired me to build my own. (This past summer I found the company that had built her microhouse: Tumbleweed Homes) Mine is quite a bit smaller, but also immensely less expensive.
I found a utility trailer frame for $100, in fact it was even a home-built trailer frame! I was fortunate enough to find five mobile home windows from the dump ( $0 ) and a source for some recycled barnwood (also $0 except for the time to sort though and find good wood). From a factories scrap pile I found five sheets of galvanized steel ( $0 with some persistant begging). I purchased two sheets of plywood (~$40 ) and with the addition of some nails and screws left over from a remodeling job I began construction.The finished (naked) Microhouse
Rather than wasting the little space I had, I decided to turn the studs flat. This made the walls only 2" thick (old barnwood, not modern) perfect for closed-cell foam insulation. After building the floor and frame and installing the windows, it was time for the wiring. Four outlets and plates, one GCFI outlet, one plug end, and wire for about $50. Now it was time to cut, bend and attach the steel sheets. Easy to say, but ended up being two 12-hour days of cutting, pounding, filing and drilling. These were not thin sheets of sheet metal. The roof consisted of the two sheets of OSB (~$25 ) and two sheets of roofing tin (donated by a friend).

(Sorry, but all the pictures from the build itself were lost)

Next the interior.

No comments:

Post a Comment