This is for converting these lights for portable / low power use.
Carefully pry open the controller to expose the control board.
Cut the end, opposite from the male connector, off of a USB cord. Remove the outer cover to about an inch; separate the wires and strip the insulation from the red and black wires. Cover and insulate the remaining wires, I used heat shrink tubing.
Drill a small hole, large enough for the USB cord, in the side of the controller case, avoiding the locking tabs.
Solder the red and black wires of the USB cord to the matching solder points on the control board, being careful to avoid disconnecting the original wires.
Re-assemble the controller case, routing the USB cable through the hole the drilled hole in the side. Connect the USB cable to a USB charger for low-power or automotive use; a battery pack (as above) for portable or off-grid use; or the plug for household use. Do not use both at the same time, or attempt to use the USB to power other devices.
No warranty is expressed or implied, I am not responsible for any damage, to property or ego, that you experience due to attempting to follow these directions. Your stupidity is your own.






No comments:
Post a Comment