Showing posts with label crafts. Show all posts
Showing posts with label crafts. Show all posts

Saturday, December 5, 2020

Converting Tree Dazzler lights for portable use,

This is for converting these lights for portable / low power use.

Carefully pry open the controller to expose the control board.

Cut the end, opposite from the male connector, off of a USB cord. Remove the outer cover to about an inch; separate the wires and strip the insulation from the red and black wires. Cover and insulate the remaining wires, I used heat shrink tubing.
Drill a small hole, large enough for the USB cord, in the side of the controller case, avoiding the locking tabs.

Solder the red and black wires of the USB cord to the matching solder points on the control board, being careful to avoid disconnecting the original wires.

Re-assemble the controller case, routing the USB cable through the hole the drilled hole in the side. Connect the USB cable to a USB charger for low-power or automotive use; a battery pack (as above) for portable or off-grid use; or the plug for household use. Do not use both at the same time, or attempt to use the USB to power other devices.





 No warranty is expressed or implied, I am not responsible for any damage, to property or ego, that you experience due to attempting to follow these directions. Your stupidity is your own.



Wednesday, October 21, 2020

Basic mead

12 pounds raw honey (wildflower preferred)

4 gallons of filtered spring or distilled water (NOT tap!)

1 packet champaine yeast

5 gallon carboy with air lock

cool (but not cold) place out of the sun (no ultraviolet), basments work well, closets will work too.

Using a large pot, warm the water on the stove and mix in the honey until it is a thin syrup, do not boil. Do this in batches and transfer each batch to the carboy, until all the honey is used and the carboy is full. Use care when transfering, you may need to allow the syrup to cool.

Activate yeast as per package directions and add to carboy after the syrup has cooled.  Stopper the carboy with the air lock and place in a cool dark place. Check in a day to ensure that the yeast is alive (lock is bubbling) and wait for it to stop. Adding yeast food will help start a stalled batch, either at the beginning or later when it begins to slow. The longer it is alive, the higher the alcohol by volume.

Some things to add for future batches, fruits (citrus peels, apples, plums), herbs (lavender, rose petals, herbal teas), or spices (pumpkin spice, peppers).


Tuesday, September 3, 2013

Vinyl graphics, part 1


Yesterday evening I got together with a friend of mine that owns a vinyl cutter and we finally started cutting the graphics for the trailer. In my previous post you saw him weeding, or removing the unwanted vinyl, on the large viking graphic for the left side. Here's the finished piece all ready for the backing.
Next we started on the large raven banner for the front of the trailer. Here I will show the steps how a vinyl graphic is made (for those that are unfamiliar).
A roll of vinyl in loaded into the machine which connects to a computer very much like a printer or a plotter. The software sends the vector designs to the cutter which begins cutting. After the machine cuts the vinyl you have a sheet with barely visible cuts on it. Beginning at the outside, we begin weeding and you can begin to see the design.

 
And here's the finished banner reading for the backing. The backing covers the design and is used for transferring the vinyl from the paper to it's destination. On the right are a couple of smaller pieces with the backer on them.
 

And those smaller pieces in place. I picked up a kindle, cheap, and it reminded me of the hitchhiker guide, so it needed "Don't Panic!" in large friendly letters on it. The other was for the kayak, which I have named the "Wetware" (it's a computer term). There is more that will be going on the kayak later.
 

It will probably be a couple days before we can get the rest cut and put on the trailer.