Monday, June 11, 2012

Solar panels and 12v wiring

Since I talked about the 110 wiring yesterday, I thought that today I would cover the 12v wiring.

I am a firm believer in renewable energy, and since solar is more portable than wind, hydroelectric or geothermal (if anyone's got a portable geyser I'll buy it off you!) that is the route I've taken. As most electronics use 12v and/or 5v for the actual circuitry, it is easy to convert them to use the 12v directly. I give an example of this below.

(BTW, that would be Domino wondering what I'm doing)
The solar panels, charge controller and battery bank is the usual setup, in fact what I have started with is a kit (minus the batteries) available from Amazon. The batteries I am using are deep cycle RV batteries, as my power requirements and not high, I've found three to be enough. I have also added a link to connect to the charging system of the van. This keeps the battery bank charged when I'm on the road and also can charge the van's battery from the panels.

I haven't decided on the form of the 12v outlets I will be using, I would like to stay away from using 'cigarette lighter' plugs. I would like something like a dual banana plug, but that is polarized so it cannot be plugged in backwards. Any suggestions?

At a festival recently I took the panels and one battery with me to demonstrate the computer I have put together. The flat panel display had a 20v power supply, but when I opened the case I found a voltage regulator took that to 12v immediately, bypassing that gave me a 12v powered screen.

The computer is a thin client. It is a small 12v powered and does not have an internal hard drive. It is designed to boot over a network or from USB. For demonstration purposes I run a modified Puppy Linux from a 1GB USB, but for everyday I have a 500GB USB HD running Ubuntu. Fully charged, a single battery can run the computer, screen and 1GB stick four about 5 hours.

No comments:

Post a Comment